Blog

LTK-RCB-5U60A resonant capacitor bank: From 3D design to manufactured hardware. LTK-RCB-5U60A is a high-current resonant capacitor bank designed for induction heating, resonant converters, and high-frequency power electronics applications. It combines five parallel polypropylene film capacitors to provide a nominal capacitance of 5.0 µF and an RMS current capability of 60 Arms at 100 kHz. This Design to Reality view presents the transition from the 3D design stage to the ma

MIS-LB10-A1: LED Bar Level Indicator Design MIS-LB10-A1 is a compact LED bar level indicator designed to display analog signal levels through a sequential 10-LED structure. The module is intended for applications where signal level, system status or general operating conditions need to be shown visually and clearly. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the compact LED bar structure is carried into

PDI-A15-MONITOR: PWM Driver Monitor Design PDI-A15-MONITOR is designed as a dedicated monitoring interface for the PDI-A15-5V1A PWM driver. It provides a compact touchscreen display structure for reviewing signal parameters, device status and configuration information during operation. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the monitor interface and compact module structure are carried into the final

PDI-A15-5V1A: SPWM Driver Design PDI-A15-5V1A is a configurable PWM driver module designed for applications where signal timing, duty cycle control and output mode selection are important. In addition to push-pull and inverted PWM modes, the module also supports sinusoidal PWM operation. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the compact driver structure and signal interface are carried into the fina

DI30A-25W10-NA: Isolated Gate Driver Design DI30A-25W10-NA is a single-channel isolated gate driver module designed for high-power switching applications. It provides up to 30 A peak gate charge and discharge capability, making it suitable for driving IGBTs and SiC MOSFETs in demanding power electronics systems. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the isolated driver structure, compact PCB layout

PDI-A14-5V1A: PWM Driver Interface Design PDI-A14-5V1A is a programmable PWM driver interface designed for two-channel push-pull PWM signal generation. It provides two signal outputs operating at the same frequency, with an adjustable frequency range from 100 Hz to 1 MHz and a duty cycle range from 0% to 50.0%. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the compact driver structure, output interface and

ZCD-28PT835A: Triac Controller Design ZCD-28PT835A is a triac and reverse-parallel SCR driver module designed for AC power control applications. It supports an 85–285 VAC RMS input range and allows the firing behavior to be controlled through the duty cycle ratio of the PWM signal supplied to the device. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the isolated AC control structure, PCB layout and driver i

ZCD-285VAC-18V6A: Zero-Cross Detector Design ZCD-285VAC-18V6A is a voltage zero-cross detector module designed to detect the points where an applied AC input signal crosses the zero-potential region. It supports an 85–285 VAC RMS input range and provides a ZCD output signal referenced to the selected output supply voltage. This Design to Reality view presents the transition from the design stage to the manufactured hardware, showing how the zero-cross detection circuit, isola